Search the Community
Showing results for tags 'Setup'.
Found 1 result
Gunna start this off with an apology because I bet a lot of these questions have been answered at some point but I'm looking to add an LCD panel into my new build for the first time and I have questions about hardware compatibility and what the AIDA64 software can output: 1) Can any LCD panel work as an external display? I've noticed that some are listed as "supported" or "not supported" but I'm not sure what that actually means. If anyone would like to suggest panels: I'm most likely looking for a panel roughly 8"-12". 2) I have an Asus Maximus VIII Formula Motherboard and plan on adding a Bitspower temp sensor fitting to my watercooling loop. I think I saw that only 1 temp sensor port could be read through the software but I wasn't sure if that had changed or the part I have in mind would cause issues. 3) I would also like to add a flow meter into my loop. However I'm not too familiar with how the signal is read since I've never used one (I believe they report in RPM since they connect to a fan header?). I'm looking for a suggestion on a flow meter that will work with AIDA64 and allow me to report in GPM or similar units. Again thanks for any help anyone can give me and I'm open to any component suggestions.