Hey, there's probably an easy answer to this that is somehow evading me but I can't seem to figure out how to keep the sensor display window open after closing the main Aida64 window. It automatically closes the sensor display as well. Any help is appreciated!
i'd like to see simple GPU benchmark for testing basic values of graphic cards like:
Pixel Fillrate (MPixel/s) - think can be found in some 3Dmarks
Texel Fillrate (MTexel/s) - think can be found in some 3Dmarks
Triangle/Vertices Rate (M/s) - don't know how gpu makers measure this, cant remember any benchmark for this one...
Best will be based on Opengl 1.1 so also very old profi cards can be tested (3DLabs, Intergpraph and similar stuff) and test won't be tied to some version of DirectX.
Fillrates can be measured by really old, outdated and no longer supported SPECglperf - https://www.spec.org/gwpg/pastissues/Feb2_02/opc.static/glperf.htm , but results have too many variants of results (see attached result file as warning how it should not look) and wont work on modern systems.
This kind of benchmark would be usefull for diagnostics between theoretical values of cards and real scenario. Also for detecting of number texture units and ROPS on cards with unknown specs - getting often mixed info from various sources about these at mobile chips or OEM cards (GPU makers ignoring them mostly and won't release any closer info).
Gunna start this off with an apology because I bet a lot of these questions have been answered at some point but I'm looking to add an LCD panel into my new build for the first time and I have questions about hardware compatibility and what the AIDA64 software can output:
1) Can any LCD panel work as an external display? I've noticed that some are listed as "supported" or "not supported" but I'm not sure what that actually means. If anyone would like to suggest panels: I'm most likely looking for a panel roughly 8"-12".
2) I have an Asus Maximus VIII Formula Motherboard and plan on adding a Bitspower temp sensor fitting to my watercooling loop. I think I saw that only 1 temp sensor port could be read through the software but I wasn't sure if that had changed or the part I have in mind would cause issues.
3) I would also like to add a flow meter into my loop. However I'm not too familiar with how the signal is read since I've never used one (I believe they report in RPM since they connect to a fan header?). I'm looking for a suggestion on a flow meter that will work with AIDA64 and allow me to report in GPM or similar units.
Again thanks for any help anyone can give me and I'm open to any component suggestions.
Sorry for my English - I use translator.
On my computer version 5.50.3600 incorrectly displays the information on the OpenGL. Previous version 5.30.3500 displays all correct.
Reports made the difference in a couple of minutes. On your computer, I have not changed anything.
In attach reports two versions.
If you need more complete reports - write.