Jump to content
  • Similar Content

    • By Caelin
      I have the latest BETA version for AIDA64 and the only sensor I am seeing from the AIO is the pump fan from the motherboard since it has a connector from the pump to the motherboard CPU fan header and it shows up as the CPU fan in AIDA64. The rest of the six fans connected to the iCUE controller core are not detected by AIDA64 and I have all the Corsair options other than Corsair Link sensor support checked in the stability section of the preferences. Attached is the USB dump you guys normally ask for in the other posts I have seen. Could use some help figuring this out to get my AIO fans detected in AIDA64 as I have a BeadaPanel to display statistics and fan speeds and would like to monitor these fans. Thanks for any help you can provide.
      usbdump.txt
    • By ViLRuX
      hello guys
      I saw a lot of thread about corsair water cooler but i have not see any with the new corsair h100i elite capellix. Corsair changed the way the cooler is connected to the board with this cooler. the pump and the fan now connect in a Commander CORE RGB & PWM Fan Controller(downgraded version of the commander pro with 6fan + 1 temps sensor) which is connected to the usb header. I can see the commander core in my usb device list in aida64 but i cant get the fan speed or the pump speed or water temps to show in the monitoring list. i already try downloading the new beta version that have the corsair hydro platinum support but it did not help. i join the corsair link dump file and the usb dump in case it can help. i also try to turn off icue and restart aida64 but aida didn't detected the commander core at all.
      i dont understand what i am doing wrong.
      the computer is a 3900xt on a asus b550-i motherboard if this change anything
      corsairlinkdump.txt
      usbdump.txt
    • By platonas
      Hi,
      I have the asus strix x470-f with 5601 bios and an outdated version of aida64(from the start of 2020).
      Chipset and Tsensor(watercooling loop temp for me) temps have stopped showing for a while now and I assumed it was from getting bios updates and not updating aida.
      Installed latest beta (6.25.5462) and the problem persists. Asus Wmi and EC support are enabled (as i always had). Later i found out the following topic with the same problem(with olded bios than mine) that you are claiming to be an Asus issue , but sensors are showing in aisuite,hardwareinfo and other programs and only aida64 doesn`t seem to find them .
       
       
    • By tistou77
      Hello

      I have a problem with rams, they are indicated as on the screen in Aida64, while it will have to be A1, B1, C1, D1


      and I have the temperature of the water plugged into the "Water In" port on the motherboard, but it indicates Temperature N°1 in Aida64

      It is possible to rename in "Water" (the "In" and "Out" to put in Extended Labels) and it's "duplicate" with T-Sensor 1
      Asus having made the effort to add these ports, as long as they are named correctly in Aida64
      And for Water Flow, in bios it is indicated in l/m, in Aida64 it is indicated in RPM
      Possible to have in l/m (see in l/h) in Aida64
      Thanks
      And merry christmas
    • By leghmoh
      Hello,
      Aida64 is reporting wrong VCCIN and DIMM AB and CD voltages, after overclocking.
      CPU is Intel 10940X and Memory is Corsair Dominator Platinum RGB 3600 Mhz.
       
      Thanks a Lot
       
      Best Regards
×
×
  • Create New...