Jump to content
AIDA64 Discussion Forum
whatabambam

Writing Sensor Values To Wmi Bug...

Recommended Posts

Hi,

i found bug in writing sensor values to WMI. It is related to do external hard drive. It shows correct values when hard drive is connected to PC but when you unplug it then WMI still shows last temperature value even if you turn off application and turn on it again without the drive. I use WMI with Samurize software. Any chance to fix that?

Best regards

Share this post


Link to post
Share on other sites

1) Are you using AIDA64 v1.85? (latest version)

2) What version of Windows are you running? 32-bit or 64-bit?

Thanks,

Fiery

Share this post


Link to post
Share on other sites

Thanks for your reply. Latest beta did not solve the problem. But it is little better. If you have AIDA64 running and you disconnect external hard drive then temperature still freeze in last value. If you close AIDA and run it again then in first secon last remembered temperature value is showing than change to 0. It would be great if AIDA64 can change temperature to 0 after hard drive discconect when application is running how it was few betas ago. Thank you.

Share this post


Link to post
Share on other sites

We've further improved the hot-plug devices support in the latest beta version of AIDA64 Extreme Edition available at:

http://www.aida64.com/downloads/aida64extremebuild1714gcn7wyrhdzzip

After upgrading to this new version, make sure to restart Windows to finalize the upgrade.

Please let me know how it works.

Thanks,

Fiery

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×