Jump to content
AIDA64 Discussion Forum
CopperMich

Not Working Anymore On G510

Recommended Posts

Hello,

Recently installed new logitech gaming software for G510.

Aida always worked , now i cant get the error away when i activate the lcd support.

Cannot get to the settings to configure the temps to display on the keyboard.

Logitech gaming soft 8.20.74

does anyone have the same prob?

Thanx

Share this post


Link to post
Share on other sites

Please avoid posting multiple topics for the same issue. I've replied in your other topic. This topic closed.

Regards,

Fiery

Share this post


Link to post
Share on other sites
Guest
This topic is now closed to further replies.

  • Similar Content

    • By beada
      BeadaFrame Display Kit is an ARM Cortex-A7 development platform which bundled with a 7" TFT LCD Display. It can be powered and communicated with PC Host by a single Micro USB cable. Currently we use it as a secondary PC monitor for display of hardware status through Remote Sensor LCD.
      The question is --  is there any way to implement it as a native support of AIDA LCD screen? We are running Debian Stretch on the ARM Cortex-A7 core.


       
      And more details of this display kit:
      CPU
      NXP/Freescale ARM Cortex-A7 i.MX6ULL
      RAM
      512MB DDR3L
      Storage
      16GB/32GB eMMC
      Connectivities
      1 x WIFI 802.11 b/g/n module(AP6212) 1 x USB 2.0 Host(Type A) 1 x USB 2.0 OTG(Micro-USB) Display
      7.0" TFT LCD: 800x480 (AT070TN92) , w/ touch and bezel
      On Board Resources
      Reset Circuit with reset button 1 x Power select jumper 1 x Boot select jumper 1 x USER LED Dimension
      188 x 118 x 35(mm)
      Operating System
      Debian Stretch
      Consumption
      5V/350mA
    • By Shaman
      Dear all,
      I am trying to figure out the best option for a small (max 7'') external screen to use with SensorPanel.
      I find lots of options on eBay that I suppose are all viable (e.g., https://www.ebay.co.uk/itm/7inch-HDMI-LCD-H-with-case-1024x600-IPS-Capacitive-Touch-Screen-Audio-Output/133067577890).
       
      What I am unsure at the moment:
      - Is the quality/resolution of the screen important?
      - Is touch input needed/used?
      - Is there any difference (limitations) between the three available options (using an HDMI connected screen, a USB connected one and/or an affordable Android tablet)? 
       
      Any input would be appreciated. Thank you in advance!
       
      Best,
      S
    • By Ventilator
      Would be nice if you could rotate output 90 degrees in AIDA 64 LCD config for Logitech ARX.
      This, so you can get tablet mode.
       
    • By Roy
      Hi,
      it would be nice if there was the possibility to send sensor values unformatted as a number or percentage, via a serial port.
      Similar to the LCD displays, only without formatting, or pure numbers with separators.
      Together with a small GUI.
      Background is the simple evaluation of the data with a microcontroller and display in different ways.
      I imagine not only LCD or OLED, but rather seven segment display, nixi tubes or an analog pointer display. That would create a lot of possibilities.
×
×
  • Create New...