[Do you have an unsupported LCD or VFD?]

On 4/15/2019 at 7:30 PM, Fiery said:

  Let me know how it works.

Thank you very much it works very well!

[Do you have an unsupported LCD or VFD?]

On 3/26/2019 at 10:52 AM, Fiery said:

we've ordered one

Hello Fiery, have you received the Rival Mouse yet?

[Do you have an unsupported LCD or VFD?]

Hello, is it possibly to add Steelseries Mouse LCD Support.

I got a Rival 710

[samsung spf-72h display panel stuck]

10 hours ago, Fiery said:

I'm sorry to hear that SPF-72H fails to provide a stable mini-monitor mode function.  We'll add a warning to the AIDA64 LCD Guide about this.

I am now trying to play a little at the update frequency. Now set it to 1200ms, if necessary I will increase it step by step by 100ms.

[samsung spf-72h display panel stuck]

On 2/5/2019 at 10:36 AM, Fiery said:

As for the hanging, it could still be due to overheating in case the controller chip inside gets too warm and the heat is not transferred properly out of the frame PCB.  Disassembling the frame and directly inspecting the chip's thermal state during operation would be a good idea, but I'm not sure if you can disassemble the frame easily at home...

I screwed on the case of my SPD-72H and exposed the circuit board. You can touch the chips with your bare hand without any risk of burning.
I am convinced that the problem is not caused by overheating.

Too bad, I think the SPF-72H should be on the list of non-functioning picture frames.

[Item Type: Sensor item / Bar / Horizontal]

On 1/29/2019 at 4:26 PM, Fiery said:

Based on your edit comment, do you still miss an aligment issue or trick?  Or is everything good now? 

I can only display the loading bars lying down, I would like to rotate them 90°.

 

[Share your Sensorpanels]

Really good Templates to see here.

This is aktually mine:

Resolution 800x480.rslcd

[Item Type: Sensor item / Bar / Horizontal]

Hi, I'm about to set up an LCD element.
What I miss most of all is the one under the
Item Type: Sensor item / Bar
The Horizontal Alignment. Did I not see that or is it just not doable?

[samsung spf-72h display panel stuck]

I also have a SPF-72H (LP07CELSS).
After a firmware update to 1012 everything worked fine. No overheating (display refreshes every 1.1 seconds). Is it possible to shorten the interval or is it already completely exhausted?

Very important info for all. Do NOT install Samsung Frame Manager for Vista 64-bit v2.00 on Windows 10 64Bit v1809 (Build 17763.292) on any CASE. You will get a BSOD and you will have to reinstall the operating system.

 

Edit:

I noticed that the SPF-72H hangs at irregular intervals. When the case arrives you have to switch it off and on again so that it continues to run properly. But I don't find the frame to be above average warm. I am therefore not very sure that it is due to overheating.