Xian65

Thank you a thousand times over. You just made my day

I know this has been done to death over the years but it's getting frustrating that disabling HWMon modules does not persist after a restart. My current situation is that I love the AIDA64 sensor panel for the multitude of hardware stats it can show. However, when the Aquaero service is active, all polling slows to a crawl. I don't really care about some of those sensors as I can use the Aqua Computer software to display the 2 values I need out of the approximately 50 I have displayed. Can we please have it so that these HWMon options get added to the stability page to allow them to be disabled? I don't want anything fixed, fingers pointed at who's fault it is, I'd just like to disable it, move on, and continue to enjoy my sensor panel at full speed.

Apologies to resurrect this thread however I am having the same issue. I've just implemented an Aquaero 6 XT into my system and the sensor panel is ridiculously slow. Looking at the polling logs, the Aquaero is taking over 1,700ms to update. Given I have an external Aquaero Vision module, I don't necessarily need AIDA64 to display this info and would much rather my system speed back. Can we please have an option to permanently disable the Aquaero polling if wanted other than just the temp method described above that comes back upon restart?

Thanks. I can confirm that the Beta has dramatically improved the sensor value responsiveness and is now showing values reliably. Cheers

Sorry Fiery, I didn't realise you had replied. Yes, that option is indeed ticked. I've attached the currently selected options in the Stability section

I have an ASUS Rampage VI Extreme board showing flapping values/disappearing values/incorrect values. Looking that the sensor section, the "PCH" and "T_Sensor #2" sensors constantly appear and disappear. Looking at my sensor panel, I can see these values constantly bouncing between correct values and showing "N/A". Very occasionally I'll see a completely incorrect value where "T_Sensor #2" which is connected to a thermal probe for water temps in my loop jump from 24 degrees to say 55 degrees and then seemingly refresh again and show the correct value. HWInfo64 is showing these values correctly and is stable. Exiting HWInfo64 so there is no conflicting polling also doesn't fix the issue. Thanks