Jump to content

francisw19

Members
  • Posts

    7
  • Joined

  • Last visited

Everything posted by francisw19

  1. Hello, I think this is likely related, so I'll add to this thread. I have a new Maximus IX Hero and seem to be missing some sensors as well. I've attached a Report and Debug info. I hope I got these right. If more info is needed on my end, just let me know. Thanks! Debug Info.txt Report.htm
  2. So, I'm using AIDA64 to monitor my system in real time. I have a Corsair H100 cooler, and I use the Alerts section to shut down my PC if the CPU temps exceed a certain temperature and if the CPU Fan RPM (same as the H100 Pump speed) falls too low in case the H100 fails. A few times now, I've had my system just shut down on me (to be clear, this is a proper shut down - NOT just instant power off). With a bit of digging, I found that AIDA64 detected the CPU Fan Speed to be "0 RPM" for just a split second and then shuts down my PC because of the alert setting I mentioned above. So, I'd like to request a feature on the Alerts settings. Perhaps something that says the particular reading must read high/low for a specified period of time before the alert is activated. For example, if the CPU Fan RPM reads "0 RPM" for 5 seconds, then shut down. I hope this makes sense. Implementing something like this would be much appreciated. Thanks!
  3. Thanks again, Fiery. It looks like you were right. I installed the Thermal Radar program provided by Asus, and now when I check the thermal sensors in AIDA64, it shows all the same sensors as the Thermal Radar. With my initial testing, you do not have to have the Thermal Radar program running...just installed. Presumably it initializes the sensors as you predicted. I've attached the embedded controller dump in case it helps to provide any more information to the developers. So, it looks like this works now. Thanks again for all your help! ecdump.txt
  4. Hi Fiery...I just want to be clear, do I need to have Thermal Radar installed/active to get the readings?
  5. Hi Fiery, Thanks again for your reply. I have attached a screen capture of the "Sensors" page. I have also attached the Embedded Controller Dump file. Let me know if there is any other information you need. ecdump.txt
  6. Thanks for looking into this! I followed your steps to upgrade and have the beta version you linked to. Unfortunately, I do not see any new temperature readings. If there is anything you need me to do to help out be sure to let me know.
  7. Hello, I just got an Asus Sabertooth P67 motherboard for my new i5 build. One of the features of this board is the 'Thermal Radar' which displays the temperatures of several sensors on the motherboard (see attached picture). Would it be possible for Aida64 to get all of the temperature sensors in the picture. I really like Aida64 and it's nice to have all these readings in one place. Right now, I only see the 'Motherboard' temperature sensor. If there is anything that can be done, it would be very much appreciated. Thanks in advance.
×
×
  • Create New...