Need help getting WFlow_1 header to report on SensorPanel (MSI MEG Z690 Unify-X)

[Fiery]

On 9/5/2025 at 10:21 AM, Winterfoot said:

also kinda interesting, the flow correction disappeared after I set it back to one. I can't put it back

Please check this issue as well with the beta I've linked above.

[Winterfoot]

I'll do a deeper dive tomorrow, BUT it appears to be working perfectly now. 

Base pump speeds (30%) gives a N/A value (minimum detectable rate likely), but once I increase the speed it reports values that seem reasonable for what it is. 35-40% is around 20-30LPH, 100% speed lands around 150LPH.

[Winterfoot]

On 9/7/2025 at 5:54 AM, Fiery said:

Please check this issue as well with the beta I've linked above.

flow correction is still not on the available list. sorry missed this thread has a second page

[Fiery]

On 9/8/2025 at 5:48 PM, Winterfoot said:

flow correction is still not on the available list. sorry missed this thread has a second page

Thank you for your feedback.  We've checked and unless flow rate is reported as zero, it should appear in the list of available items for correction.  It's puzzling if it indeed doesn't appear for you.

[Winterfoot]

I went back to double check and it is there now and modifiable... no idea why it wasn't there before.

 

[Fiery]

8 minutes ago, Winterfoot said:

I went back to double check and it is there now and modifiable... no idea why it wasn't there before.

No worries, I'm glad it works now.  The item could be removed from the list in case by the time the polling of sensor items happens the sensor reports an invalid value (momentarily).

[Winterfoot]

you know, that actually makes some sense. before I optimized fan control, i would get an N/A value purely based on sensor limitations and the pump running below the detectable limit. If i was looking for the flow correction then it wouldn't be findable. I've since optimized the fan control so it reports at least the lowest detectable limit, hence it shows back up.