AIDA64 Causes CPU temp to spike 10 degs just opening the program

[Davet73]

I Recently installed Aida64 Extreme to setup my new Gskill Wigidash  sensor panel. I can get the panel to display the hardware info, my issue is once i load Aida64 to run the profile in the panel it immediately spikes the CPU package temp by 10 degrees. Even if i do not load anything in Aida64 and just open the panel my CPU package temp will rise by around ten degrees. 

I normally run around  40-41 degrees with the system at idol. But once i Open Aida64 it rises to anywhere from 51 to 56 degrees. I monitor this on my Corsair ICUE Link AIO display as well as opening HWinfo to check the reading there. All the reading will rise the 10-15 degrees. 

If i Run the Wigidash with out Aida64 running it does not spike the temp. 

I am running the Trial Version at the moment to determine if the program is worth buying. 

Any help would be appreciated.

 

Thanks

[FatBoyNL]

Does AIDA64 show that same behavior when iCue software is not running (in the background)?

[Davet73]

 I turned off Icue ran it again with no change. Still spikes the temp by 10+ degs. 

I was up on the Gskill Wigidash forum and I am not the only one appearing to have the same issue. The general consensus is the latest version of Aida64 is the cause.