Writing Sensor Values To Wmi Bug...

[whatabambam]

Hi,

i found bug in writing sensor values to WMI. It is related to do external hard drive. It shows correct values when hard drive is connected to PC but when you unplug it then WMI still shows last temperature value even if you turn off application and turn on it again without the drive. I use WMI with Samurize software. Any chance to fix that?

Best regards

[Fiery]

1) Are you using AIDA64 v1.85? (latest version)

2) What version of Windows are you running? 32-bit or 64-bit?

Thanks,

Fiery

[whatabambam]

I use 1.85.1649 version. I notice that this problem exitst until last few betas. I am on 64 Bit Windows 7 Ultimate. Thank You.

[Fiery]

Please upgrade to the latest beta version of AIDA64 Extreme Edition available at:

http://www.aida64.co...57q7s2pwnmbdzip

After upgrading to this new version, make sure to restart Windows to finalize the upgrade.

Let me know if it helps.

Thanks,

Fiery

[whatabambam]

Thanks for your reply. Latest beta did not solve the problem. But it is little better. If you have AIDA64 running and you disconnect external hard drive then temperature still freeze in last value. If you close AIDA and run it again then in first secon last remembered temperature value is showing than change to 0. It would be great if AIDA64 can change temperature to 0 after hard drive discconect when application is running how it was few betas ago. Thank you.

[Fiery]

We've further improved the hot-plug devices support in the latest beta version of AIDA64 Extreme Edition available at:

http://www.aida64.com/downloads/aida64extremebuild1714gcn7wyrhdzzip

After upgrading to this new version, make sure to restart Windows to finalize the upgrade.

Please let me know how it works.

Thanks,

Fiery

[whatabambam]

Problem is completly solved. Everything works now fine. Thank you for your work. Greetings.

[Fiery]

Thank you for the feedback