USB-HDD disconnected when copying big massive information

[AlexLA]

Hi,

USB-HDD disconnected when copying big massive information (~40..50Gb) and AIDA is currently running.

The copying process is stopped for about 10 minutes after the start copying.

When AIDA stopped, all working good.

 

AIDA v3.00.2500

Win7x64SP3

i7-2600K / MB ASUS P8Z68-V Pro

USB-HDDs:

Seagate Backup Plus Portable STCA3000200 (an error occurred when it was connected to the USB3.0)

WD My Book Essential WDBACW0020HBK (an error occurred when it was connected to the USB2.0)

[Fiery]

1) Does the issue affect both drives?

 

2) While you have both USB drives connected, please right-click on the bottom status bar of AIDA64 main window --> Disk Debug --> RAID Dump.  Copy-paste the full results into this topic.  Let me know if it causes any of the drives to disconnect.

 

 

Thanks,

Fiery

[AlexLA]

1) Does the issue affect both drives?

 

2) While you have both USB drives connected, please right-click on the bottom status bar of AIDA64 main window --> Disk Debug --> RAID Dump.  Copy-paste the full results into this topic.  Let me know if it causes any of the drives to disconnect.

 

 

Thanks,

Fiery

 

 

1) I have not tried to connect at the same time two USB-HDD that have been described.

An error has occurred when I copied a lot of information to one of them (~40..50Gb).

It did not happen right away. Approximately 10 minutes after the start of the process.

 

2) I did not get to the previous conditions. I have already installed the new version v3.00.2584 Beta.

With this version I have not yet tested this problem.

 

I forgot to write a very important detail.

"Indicator Panel" working at the time on the Desktop. It showed a temperature indicators for USB-HDD.

 

Thank You!