AIDA64 v5.0 & aquasuite 2015 v1.0

[Dutch]

Is Aida64 v5.0 compatible with the just released aquasuite 2015 v1.0 from Aquacomputer?

[Fiery]

Yes, it should be compatible. But, since we've been rather busy with the AIDA64 v5.00 update lately, we haven't yet had a chance to actually test the new aquasuite. We'll do that later this week. Till then, let me know how it works on your system

Regards,

Fiery

[Dutch]

Heh, have not installed aquasuite 2015 yet, thought I would let it go for a bit to let some of the initial bu8gs get discovered. I believe there is an associated firmware update for the aquaero which may have a greater impact on Aida64 behavior. I will post results when I update.

[Fiery]

Heh, have not installed aquasuite 2015 yet, thought I would let it go for a bit to let some of the initial bu8gs get discovered. I believe there is an associated firmware update for the aquaero which may have a greater impact on Aida64 behavior. I will post results when I update.

We've already prepared AIDA64 to properly handle the new firmware. It wasn't tested yet, but it should work.

[Dutch]

Installed aquasuite 2015 today and updated firmware of aquaduct mark V XT (functional) and aquaero 6 XT (build mode) without any issues at this time.

[Fiery]

Installed aquasuite 2015 today and updated firmware of aquaduct mark V XT (functional) and aquaero 6 XT (build mode) without any issues at this time.

Thank you for the feedback

[Novax1]

regards

I'm using AquaSuite 2015 v.3 for Aquastream xt,

and if I can see some values AIDA64 sensores.en.

but not (cover flow and HZ) and the last option current values does not match AquaSuite.

greetings and thanks