I just replaced my 11 year old APC SUA2200I Smart UPS with a brand new APC SMT2200IC Smart UPS but now I have a 'problem' with AIDA64:
With the older unit I could use AIDA64 to monitor the UPS's internal temperature. power load in Watts, etc... For the new UPS, AIDA64 unfortunately does not show this information, only the "basic" information you can normally get with DeviceIoControl (Runtime, Charge, Serial Number, etc).
The new UPS is connected to the PC (Windows 10) via USB, exactly like the old one. APC PowerChute is not installed since their drivers replace the normal Windows HID battery drivers.
If I connect the old SUA2200I, I can see the power load, temperature, for that unit as I could before, but when I connect the new SMT2200IC that information is absent - could this be an 'issue' with AIDA64 and the new APC UPSs, the new UPS not transmitting that information, or both?
I searched around a bit (and here I am completely out of my depth) before posting here and managed to find some forum posts with more people complaining about the missing info, but they were all from users using unRAID or APCUPSD under Linux. Apparently they could solve the issue by enabling a communication protocol called ModBus on the UPS itself (which comes disabled by default). Not sure if this has anything to do with the issue given that the UPS is connected via USB on a Windows 10 system and not a serial cable.
I never-the-less did try enabling ModBus in the UPS Advanced menu but it apparently made no difference? Also, looking at the User Guide and the settings I have available in the UPS, it seems the UPS itself is missing some ModBus configuration settings? In the UPS I could only find settings to enable/disable ModBus and set the ModBus device ID (currently set to 1), and I don't even know if this has anything to do with AIDA64 not being able to get the required info or not lol.
I did try contacting APC/Schneider Electric here in Portugal but the tech I talked to had no idea either.
What say you? You are my only hope, Obi Wan.
I have the asus strix x470-f with 5601 bios and an outdated version of aida64(from the start of 2020).
Chipset and Tsensor(watercooling loop temp for me) temps have stopped showing for a while now and I assumed it was from getting bios updates and not updating aida.
Installed latest beta (6.25.5462) and the problem persists. Asus Wmi and EC support are enabled (as i always had). Later i found out the following topic with the same problem(with olded bios than mine) that you are claiming to be an Asus issue , but sensors are showing in aisuite,hardwareinfo and other programs and only aida64 doesn`t seem to find them .
The CPU Temperature on the AsRock B550M Steel Series is incorrectly reported.
Ryzen Master reports 86C while AIDA64 reports 46C
MSI AfterBurner (RTSS) reports it correctly.
I know its a brand new chipset, I'm not worried about it, just wanted you to know
So i have the cpu athlon x4 860k, gpu radeon rx 570, mbo Asus a58m-k, ram 8gb ddr3 1600mhz, HDD toshiba dt01aca100, PSU LCpower L6550(550W). And when I start ANY game on my PC temperature stucks at 64C. I have the latest bios update and it didnt fix it. I also tried stress test and temperature breaks the temperature and goes up to 65 and then the frequency drops from 4.0 GHZ to 3.22Ghz and the temp falls down to 64C. Can someone please help. My csgo starts to lag at low settings because of that. please help. sorry for bad english. Thanks for understanding.